UniPro Measuring Station versions' hystory

==============================================
ver.2.4.9
==============================================

BoxDO v.1.99.16.0

- bugfix: UniLA hangs if BoxDO acquisition is started
  (added Sleep(10) to AcqThrds.SinchronizeEx())

UniLPTX v.4.5.3.0

- BUG deleted:
  USB1.0 WriteToDevice() repeated data header in each sent buffer
  That could cause an data transfer fault (depends on firmware)

==============================================
ver.2.4.8
==============================================

LA v.1.0.0.19

- All names are fully revised and correspond to user manual


Agent2 v.2.3.7

   cmDDS, cmAM, cmFM mode bugs are fixed:
- 2 trigger output pulses per signal period
- channels' busy status (A inverted, B always busy)
   cmPhM mode implemented
- phase modulation was never functional
   cmSweep
- redesigned to support sweep time up to 100 seconds


UniLPTX v.4.5.0.0

- Fixed USB2 Cypress EEPROM write (addr++)
- Fixed USB2 Slot EEPROM write (clear FIFO)


UniLPTX v.4.5.1.0

- USB2.0: Internal Data Strobe (RW3) width is increased


UniLPTX v.4.5.2.0

- Added registry support for "Fifo Address":
  "Base Address" = 0x0378 (DWORD)
  "Fifo Address" = 0x0778 (DWORD)


==============================================
ver.2.4.7
==============================================

UniLPTX.dll v.4.4.0.0

- Recoded USB2.0 eeprom access (speed)
  USB uC firmware was fully revised


BoxDO v.1.99.14

- Fixed ADC min-max codes read from device
  Codes were always read from channel 2


==============================================
ver.2.4.7
==============================================

LA v.1.0.0.9

- New software for B-144 uncluded in unipro setup


==============================================
ver.2.4.4
==============================================

UniLPTX v.4.3.6

- Busted EEPROM operation


BoxDO v.1.99.13

- Fixed BUG RIS calibration in boxdoio.dll (IOCTL_READ)


==============================================
ver.2.4.3
==============================================

UniLPTX v.4.3.5

- Some h/w mode functions added to interface
    __GetModesCount()
    __GetModeInfo()
    __EnableMode()
    __GetActiveMode()
    __SetMode()
  some of them are modified.

- Removed __PrgDetect() after EEPROM read fail

- Key Value DWORD "Port Number" added to init
  only one port (restriction)


BoxDO v.1.99.12

- Recoded boxdoio.dll (IOCTL_READ)

- Added IOCTL_UPDATEINTERLEAVING to update
  interpolator value w/o data read


==============================================
ver.2.4.2
==============================================

UniLPTX.dll v.4.3.4
- Fixed LPT EEPROM access fail

Agent2.exe -> AFGIO.dll v.2.3.5
- Fixed "Second Agent2.exe (with second device) causes ADC read fail"


==============================================
ver.2.4.1
==============================================

ULADrv.dll v.1.0.3
- Firmware update
